Burien Toyota 5SFE Turbo Installation Instructions

download
The following parts are not required, but you may want to have on hand: 9 Fresh Toyota engine coolant 9 New engine oil (preferably synthetic) and new Toyota oil filter 9 New parts to perform a tune-up (spark plugs, distributor cap & rotor). If you do replace your plugs, you may want to use a colder plug to reduce the chance of detonation. 9 New Ignition wires, if your current wires are old 9 New Toyota fuel filter (since you’re replacing the expensive injectors) 9 Shorter oil filter union from Toyota (See step #11) 9 Tie-wraps to secure vacuum lines (See step #27) 9 Shielded audio cable (See step #26.b) 9 For automatic transmissions, consider replacing the transmission fluid with a good synthetic brand and installing an ATF cooler. Burien Toyota 5S-FE Turbocharger Installation Manual Page 2 of 20Kit Contents ¾ Toyomoto exhaust manifold ¾ Garrett TB0344 turbo (Exhaust manifold and turbo charger come attached) ¾ Intermediate pipe (‘S’ shaped pipe with blow off valve attached) ¾ Down pipe (‘J’ shaped pipe with 90° bend and exhaust flange, also has mount for oxygen sensor) ¾ Turbo intake pipe (Usually attached to turbo) ¾ 90º elbow with valve cover breather hose attached (Elbow used to mount air filter) ¾ K&N air filter ¾ HKS Racing Blow-off/Pop-off valve ¾ (4) 360cc Toyota Injectors ¾ Toyota Oil pan ¾ Toyota MAP Sensor ¾ All necessary hoses, clamps, nuts, bolts, fittings, studs, gaskets and such required to install the system.

Related Content: